Pants Stay Put Installation Information

How to install

GENERAL DIRECTIONS IMPORTANT:

• Before Adhering Pant Stay Pouch- Remove Stick from Each Pouch
• Always Remove All Sticks Before Washing Or Dry-Cleaning
• NOTE: Use Two Pant Stay Pouches Per Pant Leg (See Diagram below)

Steps to Install the Pants Stay Put Product

1. Pre-Heat Dry Iron To The Appropriate Setting For Your Pant Material- NO STEAM
2. Peel Back The Film Paper From The Pouch- Shiny Side Will Be Exposed- Now Ready To Iron
3. Place Each Pouch Vertically- Shiny Side Down On The Underside of Pant, Approximately, ½ Inch Up From The Bottom Of The Pant Hem And ¼ Inch From The Pant Crease On The Back Of The Pant Leg
4. Be sure the pouch is positioned with the slit (opening for the stick) facing toward the top of the pant
5. Place And Hold Heated Iron On Each Pouch For 30 To 35 Seconds Until Entire Surface Has Been Securely Bonded To The Pant Hem (No More Than 45 Seconds)
6. Gently Place The Pant Stick Back Into Pant Stay Pouch.Ready To Wear

WASHING INSTRUCTIONS

WARRANTY: Because Of Conditions And Use Beyond Its Control, The Manufacturer Makes No Warranty Nor Accepts Any Responsibility Other Than The Original Purchase Price Of The Product

Pants Stay Put © 2007 All Rights Reserved

Home | Contact Us | Press | Testimonials | Policies | Do's and Dont's | Installation | Friends